Page 203 - Manual Oficina Polaris RS1 2018 e 2019

FUEL SYSTEM

18.Connect the harness leads to the fuel injectors. 23.Reinstall the breather into the air box and tighten the
hose clamps retaining the air box to the throttle body
NOTE assembly.
Be sure to connect the PTO harness lead to the PTO 24.Reinstall the two screws retaining the air box
injector and the MAG harness lead to the MAG injector assembly.
to ensure proper engine operation. 25.Position the intake hose onto the air box and tighten
the hose clamp.
26.Reinstall the cargo box access panel.
19.Use a tie strap to retain the harness leads to the fuel
rail.
20.Reconnect the negative battery cable and reinstall
the driver’s seat.
21.Turn key on to allow the fuel system to prime and
inspect the fuel rail and injectors for fuel leaks.
22.Reinstall the intake plenum assembly and fasten the
lower mount to the transmission mount bracket.
• Be sure the lower air box post is placed properly 4
into the rubber grommet h.

• Be sure the air box boots fully seat onto the dual
throttle body before tightening the hose clamps j.

TORQUE
Hose Clamps:
35 in-lb (4 Nm)
Intake Manifold Mount Screw:
22 ft-lb (30 Nm)

9928689 - 2018 RZR RS1 Service Manual 4.17
© Copyright Polaris Industries Inc.