Page 234 - Manual Oficina Polaris RS1 2018 e 2019

FUEL SYSTEM

EFI DIAGNOSTICS 3. A set of three numbers will appear in the information
area.
TROUBLE CODE DISPLAY (DTC) • The first number (located far left) can range from 0 to
9. This number represents the total number of trouble
NOTE code present (example: 2 means there are 3 codes
present).
The diagnostic mode is accessible only when the check
engine MIL has been activated. • The second number (located top right) can be 2 to 6
digits in length. This number equates to the suspected
area of fault (SPN).
Use the following procedure to display diagnostic trouble • The third number (located bottom right) can be 1 to 2
codes that were activated during current ignition cycle digits in length. This number equates to the fault mode
causing the MIL to illuminate. Diagnostic trouble codes (FMI).
will remain stored in the gauge (even if MIL turns off) until
the key is turned off.

NOTE
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.

1. If the trouble code (s) are not displayed, use the
MODE button to toggle until “CK ENG” displays on
the information display area.

4. If more than one code exists, press the MODE button
to advance to the next trouble code.
5. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.

2. Press and hold the MODE button to enter the
diagnostics code menu.

4.48 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.