Page 241 - Manual Oficina Polaris RZR XP 1000 17-18

FUEL SYSTEM

EFI DIAGNOSTICS

TROUBLE CODE DISPLAY (DTC) 3. A set of three numbers will appear in the information
area.
NOTICE
• The first number (located far left) can range from 0 to
The diagnostic mode is accessible only when the check 9. This number represents the total number of trouble
engine MIL has been activated. code present (example: 2 means there are 3 codes
present).
Use the following procedure to display diagnostic trouble • The second number (located top right) can be 2 to 6
codes that were activated during current ignition cycle digits in length. This is the suspect parameter number
causing the MIL to illuminate. Diagnostic trouble codes (SPN).
will remain stored in the gauge (even if MIL turns off) until
the key is turned off. • The third number (located bottom right) can be 1 to 2
digits in length. This is the fault mode indicator (FMI).
NOTICE
4
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.

1. If the trouble code (s) are not displayed, use the
MODE button to toggle until “CK ENG” displays on
the information display area.

4. If more than one code exists, press the MODE button
to advance to the next trouble code.
5. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
2. Press and hold the MODE button to enter the codes are recorded.
diagnostics code menu.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 4.47
© Copyright Polaris Industries Inc.