Page 399 - Manual Oficina Polaris RZR XP 1000 17-18

STEERING / SUSPENSION

WALKER EVANS™ SHOCK ASSEMBLY 8. Place a new lock nut onto the shock rod. Torque the
new lock nut to specification.
1. Install new seals and O-rings on the seal head
assembly. NOTICE
2. Use the appropriate shock rod holding tool and a Do not over torque the nut or damage to the valve stack
vise to mount the shock rod vertically with the can occur.
threaded end upward.
Front Shock Rod Holding Tool: 2872429 TORQUE
Rear Shock Rod Holding Tool: PU-50931
Lock Nut:
14 ft-lbs (19 Nm)
NOTICE

If the shock rod or the mounting eyelet end is being NOTICE
replaced, apply red Loctite to the threads of the shock
shaft prior to installation. Not using Loctite may allow Make sure “Top-Out” washers are orientated as shown.
the shaft to loosen from the eyelet.

3. Install the appropriate Shock Seal Protector Sleeve
over the shaft threads.
Front Shock Seal Protector Sleeve: PU-50939
Rear Shock Seal Protector Sleeve: PU-50952

4. Install seal head assembly onto the shock shaft.
5. Remove the Shock Seal Protector Sleeve.
6. Place the compression valve stack on the rod in the
reverse order of disassembly.
7. Place valve piston on top of the compression stack.

9. Front Shocks Only: Assemble the clicker valve 8
stack on top of the fastener and install the assembly
into the reservoir body. Tighten the valve stack
fastener securely.

NOTICE

If unsure of the valve stack order, refer to “Shock
Valving” under the “Shock Service Information”
provided earlier in this section.

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 8.33
© Copyright Polaris Industries Inc.