Page 129 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

ENGINE LUBRICATION SPECIFICATIONS 4. Start engine and allow it to reach operating
temperature, monitoring gauge indication.
FLUID CAPACITY
NOTE
Oil Capacity
1.75 Quarts (1.65 L) Test results are based on the use of the recommended
engine oil (Polaris PS-4) at operating temperature, and
Oil Type
may vary considerably if any other oil is used or if
Polaris PS-4 Synthetic Engine Oil
engine is not up to temperature.
Oil Pressure Minimum Specifications
(using Polaris PS-4 at operating temperature)
1.0 PSI @ 1250 RPM (Minimum) 5. Upon assembly, torque the crankcase oil gallery plug
to specification. Apply Loctite 516 sealant to first two 3
5.0 PSI @ 7000 RPM (Minimum)
thread under plug head.
TORQUE
Oil Gallery Plug:
OIL PRESSURE TEST 11 ft-lbs (15 Nm)Apply Loctite 516 sealant to first
two thread under plug head
NOTE
The ProStar 32 engine features a low pressure
lubrication system. Use a low pressure gauge (1–10 psi Oil Pressure Minimum Specifications
/ 6.9–69 kPa) to measure oil pressure. (using Polaris PS-4 at operating temperature)
1.0 PSI @ 1250 RPM (Minimum)
5.0 PSI @ 7000 RPM (Minimum)
1. Remove the seat and engine service panel.
2. Clean the area around the main oil gallery plug q,
located on the stator cover.

3. Remove the plug and install a commercially available
Oil Pressure Gauge which displays a minimum 1-10
psi (6.9–69 kPa) range in 1 psi (6.9 kPa) increments.

NOTE
The plug thread pitch is 1/8 NPTF.

9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual 3.7
© Copyright Polaris Industries Inc.