Page 245 - Manual Oficina Polaris RS1 2018 e 2019

FUEL SYSTEM

7. Click on the link shown above, save the file to your DIGITAL WRENCH® COMMUNICATION
hard disk and then double-click the icon to start the ERRORS
update process.
If you experience problems connecting to a vehicle or
NOTE any Digital Wrench® related problem, visit the Digital
Wrench® Knowledge Base for the most current
Do not "run" or "open" the file from where they are. troubleshooting information, FAQs, downloads and
Select "save" and download them to your PC before software updates at: http://polaris.diagsys.com/.
running the install.

8. When the update is complete, the version shown on
the right side of the Digital Wrench® start-up screen
should match the update you just downloaded.

4

DIGITAL WRENCH® - DIAGNOSTIC
CONNECTOR
Located under the steering wheel attached to the frame,
connected to a sealed plug q.
NOTE
Versions and updates are subject to change.

Follow these steps to connect the diagnostic interface
cable to the vehicle to allow Digital Wrench® use:
1. Assemble the SmartLink Module and attach the PC
Interface Cable to your laptop.
2. Remove the protective cap from the Digital Wrench®
connector.
3. Connect the Vehicle Interface Cable to the Digital
Wrench® diagnostic connector.
4. Turn the ignition key to the ‘ON’ position, select the
appropriate vehicle and wait for the status to display
‘Connected’ in the lower left corner of the screen.
5. Once connected, proceed with using Digital
Wrench®.

9928689 - 2018 RZR RS1 Service Manual 4.59
© Copyright Polaris Industries Inc.