Page 140 - Manual Oficina Polaris RZR 570 13-18

ENGINE / COOLING SYSTEM

5. Upon installation, torque all fasteners to specification CYLINDER HEAD REMOVAL
and reassemble engine and vehicle as outlined in
this chapter. NOTE

The cylinder head can be serviced with the engine
installed in the chassis.
Do not rotate head assembly up side-down until the
valve tappets have been removed.

1. Remove and discard the two outer M6 bolts q that
retain the cylinder head w and the cylinder.
2. Loosen the four cylinder head bolts e evenly 1/8
turn (60 degrees) at a time until all are loose.
3. Remove and discard the cylinder head bolts e.
Replace with new upon assembly.
4. Tap cylinder head lightly with a soft faced hammer
until loose. Tap only in reinforced areas or on thick
parts of the cylinder head casting.
TORQUE
5. Remove the cylinder head w and head gasket r.
Upper Cam Chain Guide Fasteners:
7 ft-lb (10 Nm)

CYLINDER HEAD DISASSEMBLY

CAUTION
Wear eye protection during cylinder head disassembly
and reassembly or when working with the valve springs.

3.42 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.