Page 217 - Manual Oficina Polaris RZR 570 13-18

FUEL SYSTEM

4. If the resistance is correct: CPS REPLACEMENT
• Test the main harness circuit between the sensor 1. If not done already; disconnect the CPS harness
connector terminals and the corresponding pin connector (see CPS Test, page 4.30).
terminals at the ECU (see wiring diagram).
• Check the sensor mounting, air gap, flywheel encoder 2. Using an 8mm socket, remove the CPS retaining bolt
ring for damage or runout, and flywheel key. Follow the and remove the sensor from the stator cover.
CPS Replacement, page 4.31 procedure to inspect 3. Install new sensor using a light coating of oil on the
CPS and flywheel encoder ring for damage. O-ring to aid installation.
5. If the resistance is incorrect, follow theCPS 4. Torque the CPS and heat shield retaining bolts (if
Replacement, page 4.31 procedure. equipped) to specification.

TORQUE
CPS Retaining Bolt:
9 ft-lb (12 Nm)
4

9926813 R06 - 2013-2016 RZR 570 Service Manual 4.31
© Copyright Polaris Industries Inc.