Page 218 - Manual Oficina Polaris RZR 570 13-18

FUEL SYSTEM

EFI DIAGNOSTICS

INSTRUMENT CLUSTER TROUBLE CODE 3. A set of three numbers will appear in the information
DISPLAY area.
• The first number (located far left) can range from 0 to
NOTE 9. This number represents the total number of trouble
The diagnostic mode is accessible only when the check code present (example: 2 means there are 3 codes
engine MIL has been activated. present).
• The second number (located top right) can be 2 to 6
digits in length. This number equates to the suspected
Use the following procedure to display diagnostic trouble area of fault (SPN).
codes that were activated during current ignition cycle • The third number (located bottom right) can be 1 to 2
causing the MIL to illuminate. Diagnostic trouble codes digits in length. This number equates to the fault mode
will remain stored in the gauge (even if MIL turns off) until (FMI).
the key is turned off.
NOTE
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.

1. If the trouble code (s) are not displayed, use the
MODE button to toggle until “CK ENG” displays on
the information display area.

4. If more than one code exists, press the MODE button
to advance to the next trouble code.
5. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.
2. Press and hold the MODE button to enter the
diagnostics code menu.

4.32 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.