Page 304 - Manual Oficina Polaris RZR 570 13-18

TRANSMISSION

16. Remove the idler gear shaft assembly (T) and gear 20. Using a 5 mm Allen wrench, remove the screws that
cluster assembly (U) from the transmission housing secure the pinion shaft assembly (V). Lift the pinion
by pulling both assemblies straight up. shaft assembly straight up to remove it from the
housing. Note the longer screw (W) that locks the
snorkel tube.

17. Place the idler gear shaft assembly (T) and gear
cluster assembly (U) on a clean surface for
inspection. If disassembly is required, refer to “Gear 21. Remove all seals from the gearcase halves and
Cluster Disassembly”. clean the cases in preparation for assembly.
Gear Cluster Disassembly
18. Slide engagement dog (X) off of shift fork guides.
22. Remove the bearing from the reverse shaft using a
19. Remove two screws and retaining plates, then lift
shift fork (Y) and torsion spring out of transmission bearing puller. Remove the retaining ring and slide
housing. the washers, 53T gear and needle bearing off the
reverse shaft (see Figure 8-1).

23. Remove the retaining ring and engagement dog from
the reverse shaft (see Figure 8-1).

6.34 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.