Page 583 - Manual_Polaris_RZR_ProXP-20-21

ELECTRICAL

WIRING HARNESS REPLACEMENT (4- 19.Install all previously removed parts and torque
SEAT) fasteners to specification.
1. Remove the seats and disconnect the battery. TORQUE

2. Remove the fasteners retaining the rear cargo box, Body Panel Fasteners:
and remove the cargo box. 7 ft-lbs (10 Nm)
3. Remove upper and lower rear close off panels.
TORQUE
4. Remove the front bumper. Refer to Front Fascia page
11.17. Heat Shield Fasteners:
9 ft-lbs (12 Nm)
5. Remove the rear bumper. Refer to Rear Fascia page
11.18.
6. Remove the fasteners q retaining the engine heat TORQUE
shield on the right rear side. Remove the shield. Seat Base Support Bracket Fasteners:
15 ft-lbs (20 Nm)

TORQUE
Seat Bracket Fasteners (Passenger):
9 ft-lbs (12 Nm)

7. Remove the upper and lower dash. Refer to Hood /
Front Body page 11.19.
8. Remove the Ride Command display and the SCM.
9. Remove driver seat belt base.
10.Remove the throttle pedal and brake pedal assembly.
11. Remove the center console and floor. Refer to Rocker
Panels, Console, and Floor page 11.13.
12.Remove the seats and seat frames.
13.Remove the ECU cover and disconnect the harness
from the ECU.

14.Remove the front fender flairs.
15.Disconnect the wiring harness from all sensors and
controls.
16.Removal all harness retaining clips from the chassis.
Refer to Electrical Harness Retention page 12.45.

17.Remove the harness through the front of the vehicle.
12
18.Route new harness the same way as the old harness.
Refer to Electrical Harness Retention page 12.45.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 12.47
© Copyright Polaris Industries Inc.