Page 203 - Manual Oficina XP 1000 14-16

FUEL SYSTEM

ETC TEST 5. Reverse these steps for installation. Torque the ETC
Never attempt to disassemble the ETC assembly. housing retaining bolts and intake boot clamp to
Warranty is void if the end cover is opened or tampered specification.
with in any way.
TORQUE
All operating and control functions within the ETC are
pre-set. No internal servicing or adjustments may be ETC Housing Retaining Bolts:
performed. If a problem is encountered, and you 7 ft-lb (10 Nm)
determine the ETC to be faulty, contact the Polaris
Service Department for specific handling instructions. Do Intake Boot Clamp:
not replace the ETC without factory authorization. 35 in-lb (4 Nm)
Use Digital Wrench® to perform all troubleshooting of
this component. Use a Volt Ohm meter to test the vehicle
harness continuity between the ETC connector and ECU ETC LEARN PROCEDURE
connector. Refer to the wire diagram for pin-out details. If
the ETC is faulty, the entire ETC assembly must be IMPORTANT 4
replaced (see ETC / Throttle Body Replacement, page
). This procedure MUST be performed on the vehicle
whenever the ECU is replaced or reflashed or the
If code P1227 is being set, verify the following: throttle body is replaced.
1. Check power supply voltage on pin for Pedal
2. Verify voltage at pedal for supply line. Troubleshoot 1. After the reflash / ECU replacement / throttle body
wiring change, leave the key on (engine not running) for 60
3. Check the pedal for sensor/physical damage (circuit seconds. Do NOTcrank the engine during this time.
fault). Troubleshoot pedal 1 and 2 vs each other 2. Turn the key off and wait 3 minutes. During this time,
(depending on faults) the ECU will write values into memory and then
completely shut down.
ETC REPLACEMENT 3. Turn key back on and start the vehicle. The vehicle
1. Remove the cargo box access panel. should operate normally.
4. If the procedure was interrupted at any time, start
2. Remove wire harness from the ETC q.
back at step 1.

3. Remove the four bolts retaining the ETC housing to
intake plenum.
4. Remove the ETC housing and gasket from intake
plenum.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 4.35
© Copyright Polaris Industries Inc.