Page 392 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

SPRING ADJUSTMENT (FOX®)
The front and rear shocks have a ride height adjustment.
Suspension springs may be adjusted to suit different
riding conditions or vehicle payloads.

WARNING

Uneven adjustment may cause poor handling of the
vehicle, which could result in an accident and serious
injury or death. Always adjust both the left and right
spring equally.

NOTE

Refer to the shock illustrations within this procedure for
spring measurement location.

The factory setting is appropriate for nearly all riding
conditions. Since this vehicle is equipped with full skid
plates, adjustment is not necessary.
If desired, the spring setting may be adjusted to maintain
vehicle clearance height when carrying loads.
1. Raise and safely support front or rear of the vehicle
off the ground to allow the suspension to fully extend.
2. Using the shock spanner/spreader tool included in
the vehicle’s tool kit, turn the adjustment collar to
increase or decrease ride height.

Spring Adjustment ww - Factory Setting

FRONT REAR
RZR XP 1000 FOX: 2.18″ RZR XP 1000 FOX:
(5.54 cm) 10.63″ (26.99 cm)

NOTE
Always return the spring adjuster to the factory setting
after the load is removed from the vehicle. The
increased suspension height will negatively impact
vehicle stability when operating without a load.

Shock Spanner / Clutch Spreader Tool:
2878925

NOTE
DO NOT increase the spring adjustment w by more
than one inch (25.4 mm) over the factory setting.

8.44 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.