Page 235 - Manual Oficina Polaris RZR XP 1000 17-18
P. 235
FUEL SYSTEM
THROTTLE BODY REMOVAL 6. Disconnect the wire harness from the ETC r and
1. Remove the cargo box assembly (See Chapter 10 – the TMAP t located on the ends of the throttle body
Cargo Box Assembly Removalpage 10.23). assembly.
2. Be sure the engine has cooled enough to work on.
3. Loosen the hose clamps q retaining the intake
plenum w to the throttle body.
4
7. Loosen the two hose clamps y that retain the dual
throttle body assembly u to the intake adapters.
Carefully lift the throttle body assembly out of the
intake adapters.
4. Remove the two screws e retaining the intake
plenum.
8. Remove the two screw retaining the fuel rail to the
throttle body. Lift the fuel rail and injectors out of the
throttle body assembly taking care not to damage the
5. Remove the driver’s seat and disconnect the
negative battery cable. fuel injector ends.
NOTE
It is not necessary to disconnect fuel lines or the injector
harnesses to perform this procedure.
9. Reverse the previous steps to reinstall the throttle
body.
10. Upon installation of the fuel rail and injectors, lightly
lubricate injector O-rings to aid installation. Torque
the fuel rail mounting screws to specification.
TORQUE
Fuel Rail Mounting Screws:
44 in-lb (5 Nm)
9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 4.41
© Copyright Polaris Industries Inc.
