Page 486 - Manual Oficina Polaris RZR XP 1000 17-18

ELECTRICAL

INSTRUMENT CLUSTER PINOUTS 2. Push the instrument cluster e out from the back side
of the dash while securely holding the dash q and
rubber mount w.

FUNCTION PIN
CAN High 1
CAN Low 2
NOTICE
Switched Power (Vdc) 3
Do not remove the rubber mount from the dash panel.
Constant Power (Vdc) 4 Only remove the rubber mount if necessary. The bezel
r is a snap-on assembly and is a serviceable part.
Ground 5
High Beam Input 8

International Models Only INSTRUMENT CLUSTER INSTALLATION
1. Spray a soap and water mixture onto the outer
Turn Signal Input, LH 6 surface area of the instrument cluster. This will help
the instrument cluster slide into the rubber mount
Turn Signal Input, RH 7
more easily.
2. Be sure the rubber mount inside the dash is fully
INSTRUMENT CLUSTER REMOVAL installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
NOTICE
3. Hold the dash securely and insert the instrument
Do not allow alcohol or petroleum products to come in cluster into the dash. Twist the instrument cluster
contact with the instrument cluster lens. gently in a clockwise motion to properly seat the
instrument cluster into the rubber mount. Apply
1. Disconnect the wire harness connector from the pressure on the bezel while pressing down on the
back side of the instrument cluster. instrument cluster.

11.18 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.