Page 278 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ENGINE / COOLING SYSTEM

ENIGNE ASSEMBLY - TOP END 3. Install upper ring with end gap positioned as shown.

PISTON RING INSTALLATION

NOTE
Apply clean engine oil to all ring surfaces and ring lands
upon installation. Always check piston ring installed gap
before rings are installed on piston (see Chapter 3 –
Piston Ring Installed Gap, page 3.154). Clean
accumulated carbon from piston ring grooves and oil
ring lube holes if piston has been in service.

REF DESCRIPTION
y Upper Ring Gap Position
u Lower Ring Gap Position

Spring Expander Gap Position
i (PTO Side)

4. Install second ring with marking facing top of piston.
Rotate ring to position the end gap toward intake
side of piston as shown below.
REF DESCRIPTION 5. Install top ring with mark facing top of piston. Rotate
ring to position the end gap toward exhaust side of
q Top Ring (Marking up) piston as shown below.

w Second Ring (Marking up)
e Upper Rail
r Spring Expander

t Lower Rail

1. Place oil control ring expander in oil ring groove.
Rotate expander in groove until butt ends are on
PTO side of piston (see illustration 1).

NOTE
Ends must butt squarely together and must not overlap.

2. Install lower ring with end gap positioned as shown in
Step 3. REF DEFINITION

o Second Ring Gap Position
a Top Ring Gap Position

6. Be sure top and second rings rotate freely in their
grooves and do not bind when compressed by hand.

3.156 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.