Page 528 - Manual Oficina Polaris Sportsman 570 2014 a 2016

STEERING / SUSPENSION

HANDLEBAR BLOCK INSTALLATION 6. Remove the steering post nuts at the mount plate.
PROCEDURE 7. Remove the top steering bracket.

8. Remove the steering post.
STEERING POST ASSEMBLY

1. The pin (A) on the bottom side of the top handlebar
block faces down and to the front of the ATV.
2. The bottom handle bar block has a side with 3 holes,
the side with 3 holes faces up and to the front of the
ATV.
3. Align the pin (A) in the top block with the middle hole
(B) in the bottom block for proper installation. The pin
(A) and middle hole (B) should face the front of the
ATV.
4. Install the pin side bolts first and evenly tighten the
bolts down. Evenly torque the 2 front bolts to
specification. 1. Install the steering post.
2. Install the steering post nuts at the mount plate.
TORQUE
3. Install the top steering bracket.
Handlebar Adjuster Block:
14 ft-lbs (19 Nm) 4. Torque all fasteners to specification.
5. Install the steering tie rod ends from the steering
5. Install the rear bolts and tighten evenly. Evenly bracket, noting the orientation of the fasteners and
torque the 2 rear bolts to specification. bracket on the steering assembly.

NOTE 6. Install the fuel tank bracket, handle bar and pod.
Torque fasteners to specification.
There will be a slight gap on the backside of the blocks
after the procedure is performed. 7. Check the steering, the handle bars must move
freely and easily from full left to full right without
binding.
STEERING POST REMOVAL 8. Install front cab.
1. Remove the front cab.
2. Remove the handle bar pod.
3. Remove the handle bar.
4. Remove the fuel tank bracket assembly.
5. Remove the steering tie rod ends from the steering
bracket. Note the orientation of the fasteners and
bracket on the steering assembly.

8.6 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.