Page 718 - Manual Oficina Polaris Sportsman 570 2014 a 2016

ELECTRICAL

HAZARD / FLASHER MODULE 2. To remove the tail lamp electrical connector (B),
The flasher module functions directly from the battery press in on the tab on the connector to unlock the
supply. Hazard lights are functional regardless if the connector and pull the connector from the bulb
ignition is on or off. Switching the flash output to left or assembly.
right side turn signals will flash the lights accordingly. The
hazard terminal is designed for a SPST switch to connect
it to the flash output. Closing this switch will connect the
flasher driver output to both left and right turn signal
lights via two diodes. While the ignition is on, the flash
driver will be toggling on and off regardless of turn or
hazard switch position. If ignition is off, the flasher driver
will remain off until a lamp load is connected (turn or
hazards on) to reduce current draw. Two or more lamps
connected to the flash output will flash at the normal rate
in turn or hazard mode. The flash rate will double when a
single lamp is detected on the flash output in turn or
hazard mode.

REAR TAIL LAMP / TURN SIGNAL LAMP
REPLACEMENT
3. To exchange either of the bulbs, turn the housing 1/4
The turn lamp (A) and the tail lamp (B) are both located turn counter-clockwise to remove and install. Turn
in the rear lamp housing. the housing clockwise to install.

1. To remove the turn lamp electrical connector (A), pull
down on the connector lock and pull the connector
from the bulb assembly.

11.56 9926803 R06 - 2014-2016 Sportsman 325 / ETX / 450 HO / 570 Service Manual
© Copyright Polaris Industries Inc.