Page 109 - Manual Oficina Polaris RS1 2018 e 2019

ENGINE / COOLING SYSTEM

6. Rotate water pump drive tab r so it matches the 11. Install the four coolant hoses u – a that attach to the
angle of the drive slot in the engine. water pump. Be sure orientation and routing are
correct.

3

CAUTION 12.Install the right rear lower shock bolt and new nut.
The water pump drive tab and slot must be aligned Torque mounting bolt to specification.
properly during installation. Severe engine or water TORQUE
pump damage will occur if the tab and slot are not in
alignment during water pump installation. Rear Shock Mounting Bolt:
70 ft-lbs (95 Nm)
7. Maneuver water pump up through the access hole in
the skid plate on the RH side of the vehicle. 13.Install the right rear wheel. Torque wheel nuts to
8. Slide water pump into engine crankcase. specification.
9. Be sure water pump is fully seated and the drive tab
and slot are properly engaged. TORQUE
10.Install the three water pump mounting bolts y and Wheel Nuts:
torque to specification.
120 ft-lbs (163 Nm)
14.Connect the (-) negative battery cable.
15.Fill and bleed cooling system as outlined in this
chapter.
16.Install the air box access panel and seat.

TORQUE
Water Pump Mounting Bolts:
7 ft-lb (10 Nm)(Apply Loctite® 204™ to bolt threads)

9928689 - 2018 RZR RS1 Service Manual 3.23
© Copyright Polaris Industries Inc.