Page 111 - Manual Oficina Polaris RS1 2018 e 2019

ENGINE / COOLING SYSTEM

14. Install a NEW mechanical seal into the water pump 20. Install the water pump cover and three retaining bolts
housing using special tool (PU-50564) u. Press the i. Torque bolts in sequence to specification.
new mechanical seal in until it is flush with the water
pump housing.

3

TORQUE
15. Rotate water pump shaft after seal installation to Water Pump Cover Bolts:
verify free movement. 7 ft-lb (10 Nm)(Apply Loctite® 204™ to bolt threads)

16. Place impeller onto the water pump shaft.
21. Install two new water pump (O-rings) and lubricate
®
17. Apply Loctite 204 ™ to the threads of the impeller them with fresh engine oil.
bolt. Install washer and impeller bolt and torque to
specification.
TORQUE
Water Pump Impeller Bolt:
7 ft-lb (10 Nm)(Apply Loctite® 204™ to bolt threads)

18. Clean cover q and housing gasket surfaces w.

19. Install a new water pump cover gasket e.

9928689 - 2018 RZR RS1 Service Manual 3.25
© Copyright Polaris Industries Inc.