Page 175 - Manual Oficina Polaris RS1 2018 e 2019
P. 175
ENGINE / COOLING SYSTEM
11. Install the valve adjustment tappet i for each valve CYLINDER HEAD INSTALLATION
in the order they were removed. 1. Rotate the engine so the cylinder is facing up.
2. Remove the Cylinder Holding & Camshaft Timing
Plate (PU-50563) q from the cylinder.
3
NOTE
Refer to “Valve Clearance Adjustment” procedure for
proper tappet selection.
NOTE
Once the cylinder head is removed, nothing retains the
NOTE cylinder to the engine. DO NOT rotate the engine
without using the Cylinder Holding & Camshaft Timing
If any valve train components were replaced, refer to
“Valve Clearance Adjustment” procedure prior to Plate (PU-50563).
“Camshaft Installation / Timing” procedure.
3. Prepare cylinder head gasket sealing surfaces by
cleaning thoroughly to remove all residue. The head
gasket must be installed clean and dry, free from oil
or grease.
NOTE
Do not touch sealing surfaces of gasket.
4. Guide cam chain w through a new head gasket e
and install the gasket on the cylinder, locating it on
the alignment pins.
5. Carefully set the cylinder head r in place on
alignment pins.
6. Install new bolts and finger tighten the six cylinder
head bolts t evenly.
9928689 - 2018 RZR RS1 Service Manual 3.89
© Copyright Polaris Industries Inc.
