Page 172 - Manual Oficina Polaris RS1 2018 e 2019

ENGINE / COOLING SYSTEM

24.Torque the oil sump cover bolts in sequence to STARTER ONE-WAY CLUTCH ASSEMBLY
specification. Repeat the sequence to verify final 1. Install one-way clutch in clutch hub with flange of
torque. clutch q engaged in recess.

2. Clean screw threads in flywheel to remove all oil or
TORQUE grease.

Oil Sump Cover Bolts: 3. Place one-way clutch on flywheel and install the
M8 Bolts: 26 ft-lb (35 Nm) three screws. Torque screws to specification.

M6 Bolts: 106 in-lb (12 Nm) TORQUE
One-Way Clutch Retaining Screws:
25.Install the crankcase drain plug if previously removed. 9 ft-lb (12 Nm)
Torque drain plug to specification.
4. Reassemble starter one-way clutch and gear using
TORQUE
the following illustration.
Crankcase Drain Plug:
12 ft-lbs (16 Nm)

26.Install the oil cooler l. Use new O-rings 1 ( upon
installation. Torque fasteners to specification.

q Torque Limit Gear Pin t Flywheel
w Starter Gear y Screws 9 ft-lb (12 Nm)
e One Way Clutch Asm. u Torque Limit Gear Asm.
r Bolt 133 ft-lbs (180 Nm)
TORQUE
5. If starter gear was replaced, inspect the torque limit
Oil Cooler bolts:
gear.
7 ft-lbs (10 Nm)
6. After assembly, be sure the starter gear rotates in the
27.Proceed to “Flywheel Installation” and then “Cylinder clockwise direction only.
Head Installation”.

3.86 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.