Page 414 - Manual Oficina Polaris RS1 2018 e 2019

BRAKE SYSTEM

CALIPER INSTALLATION 5. Perform brake bleeding procedure as outlined earlier
in this chapter.
1. Install the brake line onto the caliper taking care not 6. Install wheel and torque wheel nuts to specification.
to allow any debris to enter the caliper.
2. Install the caliper and torque the mounting bolts w to TORQUE
specification.
Wheel Nuts:
NOTE 120 ft-lbs (163 Nm)

If disc scraper q was removed, reinstall it upon caliper
installation. 7. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Make sure the brake is not dragging when pedal is
released. If the brake drags, re-check assembly and
installation.
NOTE
If new pads are installed, refer to Brake Burnishing
Procedure, page 9.17.

TORQUE
Front Caliper Mount Bolt:
30 ft-lb (41 Nm)
Scraper Mounting Bolts:
7 ft-lbs (10 Nm)

3. Torque the banjo bolt e to specification.
TORQUE
Banjo Bolt
15 ft-lbs (20 Nm)

4. Install the adjustment set screw and turn clockwise
until stationary pad contacts disc, then back off 1/2
turn (counterclockwise).

9.22 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.