Page 458 - Manual Oficina Polaris RS1 2018 e 2019

ELECTRICAL

TESTING FOR INTERMITTENT CONDITIONS TESTING CURRENT FLOW (AMPERAGE)
Intermittent conditions are very difficult to diagnose, as Performing a current flow test requires the meter leads
when you are testing the circuit, you may not have the be inserted into the correct cavities in the meter, and be
circuit failing to indicate where the issue is. Intermittent placed in series in the circuit to be tested. Refer to your
electrical failures are almost always related to a poor Digital Multi Meter’s owner’s manual for potential model
connection that only goes open in specific situations, specific instructions. Ensure you are using acceptable
such as going over a certain kind of bump, at a certain adapters to avoid damaging the connector terminals.
temperature, or when the machine is torque loaded in Connector Probing Guidelines, page 11.7
one way.
NOTE
Here is a list of possible failures that can be associated
with an intermittent electrical failure: As there are very infrequently amperage specs
provided for circuits/components, please only perform
• Loose female terminal in an electrical connector.
this test when advised in the manual.
NOTE
If the terminals in question are the correct size/series, CAUTION
always use PV–43526 to test the drag when inserting Many circuits on this machine will exceed the 10 Amp
and removing the test terminal adapters. Compare the fuse in most Digital Multi Meters in normal operation.
effort to the drag against the known good tester
terminal for reference.

• Poor terminal to wire crimp.
• Terminal crimp that occurred at least partially on
insulation instead of the conductor wire strands.
• Terminal fretting corrosion
• Contamination/moisture corrosion
• A full or partial break of the conductor wires in the
insulation, with or without visible insulation damage.
• Improper routing, especially when it leads to chaffing
or heat damage, especially near exhaust.

You may need to use different techniques to duplicate
these concerns. These include but are not limited to:
• Moving the harness by wiggling it or flexing certain
areas.
• Pulling at or near the suspected connector.
• Pushing in different directions to flex the connector
body and try to isolate poor connections.
• Changing the temperature. This can be accomplished
with either heat guns or cold air guns.

WARNING
Always exercise caution when using these tools, and
use them for short periods of time when changing the
temp of an area. Failure to do so can lead to Serious
injury and/or damage to the machine.

11.10 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.