Page 66 - Manual Oficina Polaris RS1 2018 e 2019

MAINTENANCE

FUEL LINES THROTTLE PEDAL INSPECTION

1. Check the quick-connect fuel line q at the fuel tank This vehicle is equipped with Pedal Position Sensor q
for signs of wear, deterioration, damage or leakage. used to detect when the throttle pedal w is pushed or
Replace line(s) if necessary. released.

2. Remove the left-hand rear fender (see Rear Fender The throttle pedal should move freely and always return
Removal, page 10.12). Locate the fuel supply fitting back to its idle position when released.
w through the left rear wheel well on the upper left Check throttle pedal periodically.
side of the engine. Check the line and quick-connect
fitting for signs of wear, deterioration, damage or
leakage. Replace line if necessary. ENGINE INTAKE PRE-FILTER SERVICE
It is recommended that the engine intake pre-filter be
inspected daily. The filter should be inspected using the
following procedure:
1. The engine intake pre-filter q is located just below
the high intake cover w.

3. Be sure fuel lines are routed and retained properly.

NOTE
Make sure lines are not kinked or pinched.

2. Inspect the pre-filter. If necessary, clean with soapy
water and dry with low pressure compressed air.

2.44 9928689 - 2018 RZR RS1 Service Manual
© Copyright Polaris Industries Inc.