Page 131 - Manual Oficina Polaris RZR 570 13-18

ENGINE / COOLING SYSTEM

29. Remove the four bolts and nuts (M) securing the 34. Select the proper engine stand sleeve adapter and
engine to the front motor mount bracket. install it onto the engine stand adapter.
Sleeve adapter for a 2″ bore engine stand:
PU-50625

Sleeve adapter for a 2.375″ bore engine stand:
PW-47054

35. Place engine onto the engine stand for service.

Engine Stand 3
PU- 50624

ENGINE INSTALLATION
Use the following procedure to reinstall the engine
assembly.
30. Remove the eight bolts (N) securing the coupler 1. Attach engine with suitable lifting straps to an
brackets to the engine and transmission. overhead or portable engine hoist.
31. Loosen the two bolts and nuts (O) so the engine 2. Remove the engine stand adapter plate.
mount bracket can be slightly tilted away from 3. Use the overhead or portable engine hoist and
engine.
suitable engine straps to lower the engine into the
32. With the help of an assistant and the engine hoist, vehicle frame.
raise the engine vertically out of the vehicle frame.
NOTE
NOTE Have an assistant help guide the engine in and out of
Have an assistant help guide the engine in and out of the vehicle while using an engine hoist to prevent
the vehicle while using an engine hoist to prevent personal injury or damage to vehicle components.
personal injury or damage to the vehicle components.
4. By hand, install the four front engine mount bolts and
33. Install the engine stand adapter onto the engine PTO nuts (A). Do not tighten at this time.
side mounting ears as shown below.

5. Instal the four engine to transmission coupler plates
(B) and instal the eight bolts and washers (C). Do not
tighten fasteners at this time.
Engine Stand Adapter
PU-50824 NOTE

DO NOT torque fasteners at this time.

9926813 R06 - 2013-2016 RZR 570 Service Manual 3.33
© Copyright Polaris Industries Inc.