Page 208 - Manual Oficina Polaris RZR 570 13-18

FUEL SYSTEM

18. Torque PFA nut to specification using the Fuel Pump 24. Test the fuel pump by turning on the key and
Service Tool (PU-50326) and a calibrated torque listening for the pump to activate. Cycle the key
wrench. several times to prime the system.

FUEL TANK REMOVAL

NOTE
Syphon as much fuel from the tank as possible before
attempting to remove it from the vehicle.

CAUTION
Always wear safety goggles when working with high
pressure or flammable fluids. Failure to do so could
result in serious injury or complications.

1. Remove the driver and passenger seats along with
the rear service panel.
2. Disconnect the negative battery cable from the
TORQUE battery located under the driver’s seat.

Fuel Pump PFA Nut: 3. While holding a shop towel over the fuel line
70 ft-lbs (95 Nm) connector, disconnect the quick connect fuel line q
from the fuel pump. Move the fuel line out of the way
19. Verify alignment of fuel pump and tank orientation for tank removal.
marks.
NOTE
20. Connect the fuel line to the fuel pump outlet.
A small amount of fuel may come out of the fuel line or
tank. Properly drain fuel into a suitable container.

NOTE
4. Disconnect the fuel pump electrical harness w.
Be sure to engage the retainer on fuel line until it snaps
into place. Pull on fuel line lightly to confirm connection. 5. Remove the fuel tank vent hose clamp with a
suitable pliers and remove the vent line e from the
tank vent fitting.
21. Connect the fuel pump electrical harness.
22. Connect battery.
23. Install the driver and passenger seat.

4.22 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.