Page 320 - Manual Oficina Polaris RZR 570 13-18
P. 320

TRANSMISSION


                36. Install the detent pawl onto the shift shaft and  41. Install the transmission drain plug and torque to
                   carefully install the compression spring.             specification.
                                                                                         TORQUE

                                                                                       Fill / Drain Plug:
                                                                                       12 ft-lbs (16 Nm)

                                                                     42. Install the bell Crank onto the shift shaft. Note the
                                                                         key splined on the bell Crank and shift shaft. Install
                                                                         the nut and torque to specification.
                                                                                         TORQUE
                                                                                        Bell Crank Nut:
                                                                                       15 ft-lbs (20 Nm)

                                                                     43. Refer to Chapter 8 – Transmission Installation, page
                                                                         6.10 to complete the repair.

                37. Install a new O-ring on each shift shaft. Apply a small
                   amount of white lithium grease on the O-rings, shift
                   shafts and component contact surfaces prior to
                   installing the sector cover.





















                38. Clean the transmission and gear sector cover mating
                   surfaces thoroughly.
                39. Apply Crankcase Sealant (3-Bond) (PN 2871557)
                   onto the cover and transmission case mating
                   surface.
                40. Install the sector cover and align the transmission
                   case dowel with the alignment hole. Install and
                   torque the bolts to specification.
                                    TORQUE
                                Sector Cover Bolts:
                                  11 ft-lb (15 Nm)













                6.50                                                               9926813 R06 - 2013-2016 RZR 570 Service Manual
                                                                                               © Copyright Polaris Industries Inc.
   315   316   317   318   319   320   321   322   323   324   325