Page 356 - Manual Oficina Polaris RZR 570 13-18

FINAL DRIVE

GEARCASE ASSEMBLY 5. Carefully install the rollers into the roll cage
1. As mentioned during gearcase disassembly section, assembly while installing the assembly into the
replace all O-rings, seals and worn components. clutch housing.
2. Install pinion shaft assembly and install internal snap NOTE
ring.
Install the roll cage so that the ring gear grooves line up
NOTE with the roll cage slots (see below).
If bearing replacement was required, press new bearing
onto the pinion shaft and install a new external snap
ring.

3. Install a new pinion shaft seal into the pinion gear
housing. Using a universal seal installer, press the
new seal into the housing until the seal is just below
the housing chamfer.

6. Install the torsion spring by wrapping each leg of the
spring around the dowel pin on the ring gear.

4. Install the RH output hub into the gearcase housing.

7.32 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.