Page 397 - Manual Oficina Polaris RZR 570 13-18
P. 397
BRAKE SYSTEM
PARKING BRAKE INSPECTION PARKING BRAKE CABLE ADJUSTMENT
1. Inspect parking brake cable for wear. If adjustment is When the parking brake is fully engaged and “BRAKE” is
necessary, refer to Parking Brake Cable Adjustment, displayed on the instrument cluster, engine speed is
page 9.11. limited to 1500 RPM while in gear. If throttle is applied,
this limiting feature prevents operation, which protects
the parking brake pads from excessive wear.
NOTE
Inspect parking brake cable tension after the first 25
hours of operation and every 100 hours of operation
afterwards to ensure proper cable tension.
Loss of tension in the parking brake cable will cause
illumination of the parking brake indicator and activation
of the limiting feature. If this occurs, inspect and adjust
parking brake cable tension. If performing this service is
difficult due to conditions or location, temporarily
disconnect the parking brake switch electrical connector.
Reconnect the connector as soon as practicable and
2. Inspect the outboard w and inboard e parking brake adjust the parking brake cable to proper tension.
pads. Refer to New Brake Pad Installation, page 1. Pull back on parking brake lever (located in the
9.15for brake pad replacement.
dash).
2. After 3 to 4 clicks “BRAKE” should display on the
instrument cluster and the wheels should not rotate
when turning by hand. After 8 full clicks of lever
travel, the vehicle should not roll while parked.
3. If the vehicle moves, adjustment is necessary.
4. Adjust the parking brake cable where it attaches to
the caliper mount / shift cable bracket. The mount
bracket is located on the right-hand side of the
transmission.
Adjustment Procedure
5. Place the vehicle in neutral on a flat level surface.
6. Locate the parking brake cable adjustment area
where the cable attaches to the caliper mount 9
bracket q.
9926813 R06 - 2013-2016 RZR 570 Service Manual 9.11
© Copyright Polaris Industries Inc.
