Page 417 - Manual Oficina Polaris RZR 570 13-18

BRAKE SYSTEM

PAD ASSEMBLY / INSTALLATION 4. Slowly pump the brake pedal until pressure has been
1. Lubricate mounting bracket pins with a light film of built up. Maintain at least 1/2, (12.7 mm) of brake
silicone grease and install rubber dust boots. fluid in the reservoir to prevent air from entering the
brake system.
5. Install the adjustment set screw and turn clockwise
until the stationary pad contacts the disc, then back
off 1/2 turn.
6. Verify fluid level in reservoir is up to the MAX line
inside reservoir and install reservoir cap.

Master Cylinder Fluid
Up to MAX line inside reservoir

7. Install wheel and torque wheel nuts to specification.
TORQUE

Wheel Nuts:
RZR 570 Steel Rims: 36 ft-lbs (49 Nm)
RZR 570 EPS Alum. Rims: 120 ft-lb (163 Nm)
RZR S 570 Alum. Rims: 30 ft-lbs (41 Nm) + 90°
2. Compress mounting bracket and make sure dust
boots are fully seated. Install pads with friction
material facing each other.

WARNING
If brake pads are contaminated with grease, oil, or
liquid soaked do not use the pads. Use only new clean
pads.

3. Install caliper and torque the new mounting bolts to
specification.

9

TORQUE
Rear Caliper Mount Bolt:
44 ft-lbs (60 Nm)

9926813 R06 - 2013-2016 RZR 570 Service Manual 9.31
© Copyright Polaris Industries Inc.