Page 414 - Manual Oficina Polaris RZR 570 13-18

BRAKE SYSTEM

DISC REPLACEMENT 6. Install wheel hub assembly, washers, and castle nut.
1. Remove the front brake caliper (see Chapter 9 – Torque castle nut to specification and install a new
FRONT CALIPER SERVICE, page 9.22). cotter pin.
2. Remove wheel hub cotter pin, castle nut and TORQUE
washers.
Front Wheel Hub Nut:
3. Remove the wheel hub assembly from the vehicle 80 ft-lb (108 Nm)
and remove the four bolts retaining the disc to the
hub. 7. Install the front brake caliper (see Chapter 9 –
FRONT CALIPER SERVICE, page 9.22).
8. Follow bleeding procedure outlined earlier in this
chapter.

9. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Make sure the brake is not dragging when pedal is
released. If the brake drags, re-check assembly and
installation.

4. Clean the wheel hub mating surface and install new
disc on wheel hub.
5. Install new bolts and torque to specification.
TORQUE
Rotor bolts:
30 ft-lbs (41 Nm)

CAUTION

Always use new brake disc mounting bolts. The bolts
have a pre-applied locking agent which is destroyed
upon removal.

9.28 9926813 R06 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.