Page 135 - Manual_Polaris_RZR_ProXP-20-21

MAINTENANCE

WHEEL TOE ALIGNMENT INSPECTION 4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
1. Place machine on a smooth level surface and set hub/axle center line.
steering wheel in a straight ahead position. Secure
the steering wheel in this position.
2. Place a chalk mark on the center line of the front tires
approximately 10″ (25.4 cm) from the floor or as close 2
to the hub/axle center line as possible q.

5. Measure the distance between the marks and record.
Call this measurement e. Subtract measurement e
from measurement w, this is the vehicle toe. Toe-out
means the measurement at the front of the tire w is
wider than the measurement at the rear e. Toe-in is
NOTICE just the opposite.
It is important the height of both marks be equally
positioned to get an accurate measurement.

3. Measure the distance between the marks and record
the measurement. Call this measurement w.

MEASUREMENT
Wheel Toe:
1/4” (6.35 mm) toe-in – 1/4” (6.35 mm) toe-out

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 2.49
© Copyright Polaris Industries Inc.