Page 131 - Manual_Polaris_RZR_ProXP-20-21

MAINTENANCE

DRIVE SHAFT BOOT INSPECTION WHEEL INSTALLATION
Inspect the front and rear drive shaft boots q for 1. Verify the transmission is still in PARK.
damage, tears, wear or leaking grease. If the boots
exhibit any of these symptoms, they should be replaced. 2. Place the wheel in the correct position on the wheel
Check to see the boot clamps w are properly positioned. hub t. Be sure the valve stem w is toward the
Refer to Drive Shaft CV Joint / Boot Replacement for outside and rotation arrows on the tire point toward
drive shaft boot replacement. forward rotation. 2
3. Attach the wheel nuts q and finger tighten them.
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts and/or hub nut e to the proper
torque specification.
TORQUE
Wheel Lug Nuts:
120 ft-lbs (163 Nm)

Hub Castle Nuts:
180 ft-lbs (244 Nm)

6. If hub nut was removed, install a new cotter pin r
after the hub nut has been tightened. If the holes do
not line up, turn the hub nut counter-clockwise until
WHEEL REMOVAL the cotter pin can be installed.
1. Position the vehicle on a level surface.
2. Place the transmission in PARK and stop the engine.

3. Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the wheel cap, cotter pin and
loosen the hub nut slightly.

4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5. Remove the wheel nuts and remove the wheel.

CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 2.45
© Copyright Polaris Industries Inc.