Page 397 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

10.Inspect he AWD coil located in the outer cover plate 14.Inspect the roll cage assembly sliding surfaces and
assembly. Refer to AWD diagnosis for detailed H-springs 1(. The sliding surfaces must be clean and
inspection process. Replace the cover plate seal and free of nicks, burrs, or scratches. If damaged, replace
O-ring the roll cage assembly.

11. Remove the roll cage assembly and rollers from the 15.Inspect both output hub assemblies. Inspect the
clutch housing. Use a shop towel to cover the bearings and replace if needed.
housing in order to retain all the rollers.
NOTICE
Rollers are spring loaded. Take care not to allow them
to fall out or lose them upon removal of the roll cage.

12.Thoroughly clean all parts and inspect the rollers j
for nicks and scratches. The rollers must slide up,
down, in and out freely within the roll cage k sliding
surfaces and H-springs.

8

2) Bearing 2@ Thrust Bearing

2! Roller Surface

16.Clean and inspect all remaining front gearcase
components. Check each for excessive wear or
damage.

NOTICE
Refer to the “Electronic Parts Catalog” for individual
part availability. Most parts are to be replaced as an
assembly or as a complete kit.

13.Inspect clutch housing / ring gear l for a consistent
wear pattern. Inspect the ring gear for chipped,
broken, or missing teeth.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 8.39
© Copyright Polaris Industries Inc.