Page 399 - Manual_Polaris_RZR_ProXP-20-21

FINAL DRIVE

8. Check the action of the springs by rotating in both 10.Carefully install the ring gear and roll cage assembly
directions to ensure the spring and retainer are i into the gearcase housing.
installed properly.

11. Install a new O-ring on the cover plate assembly.
9. Install the armature plate y and cage plate u. Be
sure all of the armature plate tabs are fully engaged NOTICE
into the roll cage assembly and that it is resting Be sure the square O-ring is placed flat on the cover
properly on the spring retainer. Be sure the cage plate surface. If the O-ring is twisted, fluid leakage may
is resting properly on the spring retainer, and all tabs occur.
are fully engaged.

12.Carefully install the LH output hub assembly o into
the cover plate. Take care not to damage the new
cover plate seal while installing the output hub.

8

NOTICE
Verify armature plate tabs are in the roll cage slots and
that it rests properly on the spring retainer.

9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual 8.41
© Copyright Polaris Industries Inc.