Page 490 - Manual_Polaris_RZR_ProXP-20-21

BRAKE SYSTEM

MASTER CYLINDER
MASTER CYLINDER REMOVAL 3. Place a container to catch brake fluid under the
1. Locate the master cylinder q above the left front tire master cylinder brake line banjo bolts r.
in the wheel well area.
CAUTION
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.

NOTICE
Make note of front and rear brake line locations to
master cylinder.

4. Loosen the brake line banjo bolts and allow fluid to
drain.
NOTICE
Dispose of fluid properly. Do not re-use.
2. Remove the clip w from the clevis pin e that 5. Remove the two mounting fasteners t that secure
attaches the master cylinder to the brake pedal lever. the master cylinder to the frame.

MASTER CYLINDER INSTALLATION
1. Install new stat-o-seal, rear brake line banjo fitting,
new stat-o-seal and banjo bolt to the rear port on the
master cylinder.

IMPORTANT
Lubricate seals with a thin film of DOT 4 brake fluid
prior to installation.

10.12 9930583 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.