Page 124 - Manual Oficina XP 1000 14-16

ENGINE / COOLING SYSTEM

ENGINE DISASSEMBLY / INSPECTION - BOTTOM END

STATOR COVER REMOVAL / INSPECTION 2. Carefully pry the stator cover off the engine using the
two pry areas as shown.
NOTE
The stator cover can be removed with the engine
installed in the chassis.

1. Remove the thirteen screws retaining the stator
cover.

CAUTION

The flywheel contains powerful magnets. Use caution
when removing and installing the stator cover. DO NOT
place fingers between cover and crankcase at any time
during the removal / installation process or injury could
result.

3. Inspect the condition of the stator windings q and
output wires w. If replacement is required, refer to
the Electrical chapter.

4. Inspect the ball bearing e that supports the starter
motor shaft.

3.46 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.