Page 194 - Manual Oficina XP 1000 14-16

FUEL SYSTEM

9. If the pump still does not operate, check for correct 5. While holding a shop towel over the fuel line
ECU operation by plugging in a known-good ECU of connectors, disconnect the fuel supply line w from
the same model. the pump and the fuel return line (B) from the tank
(see Chapter 2 – Fuel Lines, page 2.20 for specific
NOTE removal procedures).
If the pump still does not operate, replace the fuel pump
assembly. CAUTION
It is possible for pressurized fuel to be present when
disconnecting the fuel line.It is recommended to allow
FUEL PUMP REPLACEMENT the vehicle to sit for a period of one hour after shutting
off the engine before servicing the fuel pump. This
1. Move the vehicle to a well ventilated area. Shift the allows the exhaust to cool and fuel pressure to drop.
transmission into Park and turn the ignition key off.
2. Remove the passenger seat to access the fuel
pump. NOTE
A small amount of fuel may come out of the fuel lines or
WARNING pump fitting. Properly drain fuel into a suitable
container.
Always wear safety goggles when working with high
pressure or flammable fluids. Failure to do so could
result in serious injury or complications. 6. Disconnect the fuel pump electrical harness e.

3. Be sure the top of the fuel tank is clean q. If it
requires cleaning, hand wash the top of the tank to
ensure no debris will enter the fuel system when the
fuel pump is removed.

WARNING
Failure to clean area around fuel pump may lead to
debris entering the fuel tank during service. Excessive
debris in fuel tank may cause premature wear of fuel
pump and/or clogging of internal fuel filters.

4. Ensure that static has been discharged by touching a
ground source such as the engine or frame.

4.26 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.