Page 324 - Manual Oficina XP 1000 14-16

FINAL DRIVE

19. Install and tighten the small clamp e using the 2016 CV JOINT SERVICE
appropriate clamp tool.
OUTER CV JOINT / BOOT REPLACEMENT
1. Use a side cutters to cut and discard the boot clamps
q.

Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226

2. Remove the large end of the boot from the CV joint
20. Pull out on the drive shaft to center the joint in the
housing. Slide a straight O-ring pick or a small and slide the boot down the shaft.
slotted screw driver between the large end of the
boot and the joint housing and lift up to equalize the
air pressure in the boot.
21. Position the boot lip in its groove. Install and tighten
the large clamp r using the appropriate clamp tool.

3. Clean the grease from the face of the joint.
4. Pull the joint / shaft assembly straight out from the CV
housing.

Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226

7.22 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.