Page 37 - Manual Oficina XP 1000 14-16

P. 37

MAINTENANCE

PERIODIC MAINTENANCE CHART

PRE-RIDE / DAILY INSPECTION Severe Use Definition
Perform the following pre-ride inspection daily, and when • Frequent immersion in mud, water or sand
servicing the vehicle at each scheduled maintenance. • Racing or race-style high RPM use
• Prolonged low speed, heavy load operation
• Engine Oil - Check for proper level on dipstick (see • Extended idle 2
Chapter 2 –Engine Oil Level, page 2.10) • Short trip cold weather operation
• Tires - check condition and pressures
• Fuel tank - fill to proper level Pay special attention to the oil level. A rise in oil level
• All brakes - check operation and fluid level and during cold weather can indicate contaminants collecting
adjustment (includes parking brake on INT’L Model) in the oil sump or crankcase. Change oil immediately if
• Headlights/Taillights/Brakelights - also check operation the oil level begins to rise. Monitor the oil level, and if it
of all indicator lights, instrument cluster and switches continues to rise, discontinue use and determine the
• Ignition switch - check for proper function cause or see your dealer.
• Wheels - check for tightness of wheel nuts and axle
nuts; check to be sure axle nuts are secured by cotter BREAK-IN PERIOD
pins
• Engine Intake Pre-Filter - Inspect pre-filter and clean The break-in period consists of the first 25 hours of
with soapy water and low pressure compressed air if operation. Careful treatment of a new engine and drive
necessary components will result in more efficient performance and
• PVT Intake Pre-Filter - Inspect pre-filter and clean with longer life for these components.
soapy water and low pressure compressed air if • Drive vehicle slowly at first while varying the throttle
necessary position. Do not operate at sustained idle.
• Steering - check for free operation noting any unusual • Perform regular checks on fluid levels and other areas
looseness in any area outlined on the daily pre-ride inspection checklist.
• Loose parts - visually inspect vehicle for any damaged • Change both the engine oil and filter after 25 hours or
or loose nuts, bolts or fasteners one month.
• Engine coolant - check for proper level at the recovery • See “Owner’s Manual” for additional break-in
bottle
• Drive Shaft Boots - Inspect inner and outer boots for information.
tears or damage on both front and rear drive shafts
• Check all front and rear suspension components for MAINTENANCE CHART KEY
wear or damage.
The following symbols denote potential items to be
aware of during maintenance:
PERIODIC MAINTENANCE OVERVIEW ■ = CAUTION: Due to the nature of these
Inspection, adjustment and lubrication of important adjustments, it is recommended this service be
components are explained in the periodic maintenance performed by an authorized Polaris dealer.
chart. ▶ = SEVERE USE ITEM: See information provided
above.
Inspect, clean, lubricate, adjust and replace parts as E = Emission Control System Service (California).
necessary. When inspection reveals the need for
replacement parts, use genuine Pure Polaris parts NOTE
available from your Polaris dealer.
Inspection may reveal the need for replacement parts.
NOTE Always use genuine Polaris parts.

Service and adjustments are critical. If you’re not
familiar with safe service and adjustment procedures,
have a qualified dealer perform these operations. WARNING
Improperly performing the procedures marked ■ could
result in component failure and lead to serious injury or
Maintenance intervals in the following chart are based
upon average riding conditions and an average vehicle death. Have an authorized Polaris dealer perform these
speed of approximately 10 miles per hour. Vehicles services.
subjected to severe use must be inspected and serviced
more frequently.

32 33 34 35 36 37 38 39 40 41 42