Page 383 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

WALKER EVANS™ SHOCK ASSEMBLY TORQUE
1. Install new seals and O-rings on the seal head Lock Nut:
assembly.
14 ft-lbs (19 Nm)
2. Use the appropriate shock rod holding tool and a
vise to mount the shock rod vertically with the
threaded end upward. NOTE
Make sure “Top-Out” washers are orientated as shown.
Front Shock Rod Holding Tool: 2872429
Rear Shock Rod Holding Tool: PU-50931

3. Install the appropriate Shock Seal Protector Sleeve
over the shaft threads.
Front Shock Seal Protector Sleeve: PU-50939
Rear Shock Seal Protector Sleeve: PU-50952

4. Install seal head assembly onto the shock shaft.
5. Remove the Shock Seal Protector Sleeve.
6. Place the compression valve stack on the rod in the
reverse order of disassembly.
7. Place valve piston on top of the compression stack.

9. Front Shocks Only: Assemble the clicker valve
stack on top of the fastener and install the assembly
into the reservoir body. Tighten the valve stack
fastener securely.

8

NOTE

If unsure of the valve stack order, refer to “Shock
Valving” under the “Shock Service Information”
provided earlier in this section.

8. Place a new lock nut onto the shock rod. Torque the
new lock nut to specification.
NOTE
Do not over torque the nut or damage to the valve stack
can occur.

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 8.35
© Copyright Polaris Industries Inc.