Page 404 - Manual Oficina XP 1000 14-16

STEERING / SUSPENSION

35.Depress shaft assembly deep enough so that TORQUE
negative spring assembly is just below inner body
top. Shock Bearing Assembly:
35 ft-lb (47 Nm)

36.Slide bearing assembly into position seated on inner
body.
42.On 2.5 Bypass shocks with Aluminum body, apply
37.Remove cinch ring from assembly and wipe out all oil 290 wicking Loctite to bearing assembly threads. 3.0
residue.
Bypass shocks with steel outer bodies do not require
38.Clean cinch ring thoroughly. 290 Loctite on the bearing assembly threads.
NOTE
On remote reservoir assemblies, lubricate o-rings with
Slick Honey prior to installing hose assembly. With hose
fully seated install retaining ring, Ensure retaining ring is
fully seated by pulling back on hose.

43.With shaft full extended, remove bleed screw and o-
ring.
44.Always set IFP with a down motion of IFP tool. (oil
should be above IFP when completed). Refer to the
Shock Specifications tables at the beginning of this
section for proper IFP depth.
45.After setting IFP depth, install Bleed screw with o-
ring.
39.Run cinch ring down to the bottom thread on bearing
assembly. 46.Install reservoir end cap o-ring and lubricate with
Slick Honey.
40.Install retaining ring, ensuring that it is fully seated in
ring gland.
41.Holding cinch ring spanner, torque bearing assembly
to specification.

8.56 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.