Page 45 - Manual Oficina XP 1000 14-16

P. 45

MAINTENANCE

ENGINE OIL AND FILTER CHANGE 6. Using the Oil Filter Wrench (PU-50105), turn the oil
Always change engine oil and filter at the intervals filter w counter-clockwise to remove it.
outlined in the Periodic Maintenance Chart. Always
change the oil filter whenever changing the engine oil.
The engine oil dipstick is located on the front side of the
engine. Access the dipstick through the engine service 2
panel.
The engine oil fill cap is located on top of the valve cover.
Access the oil fill cap through the cargo box access
panel.
The crankcase drain plug is located on the bottom of the
crankcase. Access the drain plug through the skid plate
access hole located directly under the crankcase.
1. Position vehicle on a level surface and place the
transmission in PARK.
2. Stop the engine and allow it to cool down.
Oil Filter Wrench:
3. Clean the area around the crankcase drain plug. PU-50105: 2.5″ (64 mm)

CAUTION
7. Using a clean dry cloth, clean the filter sealing
Use caution when performing this procedure.Do not surface on the engine crankcase.
allow hot engine oil to come into contact with skin, as 8. Lubricate the O-ring on the new oil filter with a film of
serious burns may result.
fresh engine oil. Check to make sure the O-ring is in
good condition. Install it by hand until the O-ring
4. Place a drain pan under the engine crankcase and contacts the sealing surface, then turn an additional
remove the drain plug q. Allow the oil to drain 1/2 turn.
completely.
TORQUE
Oil Filter Torque:
Turn by hand until filter O-ring contacts sealing surface,
then turn an additional 1/2 turn
9. Replace the sealing washer on drain plug.

NOTE
The sealing surface on the drain plug should be clean
and free of burrs, nicks or scratches.

10. Reinstall the engine crankcase drain plug. Torque
drain plug to specification.
TORQUE
5. Remove the seats and engine service panel to
access the oil filter. Engine Oil Drain Plug:
12 ft-lbs (16 Nm)

40 41 42 43 44 45 46 47 48 49 50