Page 482 - Manual Oficina XP 1000 14-16

ELECTRICAL

Park Brake Indicator 3. A set of three numbers will appear in the information
This warning is used to notify the operator that the park area.
brake lever is engaged (if equipped). • The first number (located far left) can range from 0 to
When the park brake is fully engaged, “BRAKE” appears 9. This number represents the total number of trouble
in the rider information display. Engine speed is limited to codes present (example: 2 means there are 3 codes
1500 RPM in all gears, except neutral. If throttle is present).
applied, this limiting feature prevents operation, which • The second number (located top right) can be 2 to 6
protects the park brake pads from excessive wear. digits in length. This number equates to the suspected
area of fault (SPN).
• The third number (located bottom right) can be 1 to 2
digits in length. This number equates to the fault mode
(FMI).

DIAGNOSTIC MODE

IMPORTANT
Most trouble codes are set as a result of damaged
wiring or a component that was not hooked up correctly.

4. Use the trouble code reference table in the EFI
The diagnostic mode is accessible only when the check
engine MIL has been activated. Chapter for a description of each code (see Chapter
4 – Diagnostic Trouble Code List, page ).
Use the following procedure to display diagnostic trouble
codes that were activated during current ignition cycle 5. If more than one code exists, press the MODE button
causing the MIL to illuminate. Diagnostic trouble codes to advance to the next trouble code.
will remain stored in the gauge (even if MIL turns off) until 6. To exit the diagnostic mode, press and hold the
the key is turned off.
MODE button or turn the ignition key OFF once the
1. If the trouble code (s) are not displayed, use the codes are recorded.
MODE button to toggle until “CK ENG” displays on NOTE
the information display area.
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.

2. Press and hold the MODE button to enter the
diagnostics code menu.

11.10 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.