Page 483 - Manual Oficina XP 1000 14-16

ELECTRICAL

INSTRUMENT CLUSTER PINOUTS 2. Push the instrument cluster e out from the back side
of the dash while securely holding the dash q and
rubber mount w.

FUNCTION PIN
CAN High 1
CAN Low 2
NOTE
Switched Power (Vdc) 3
Do not remove the rubber mount from the dash panel.
Constant Power (Vdc) 4 Only remove the rubber mount if necessary. The bezel
Ground 5 r is a snap-on assembly and is a serviceable part.
High Beam Input 8

Fuel Level Sensor 11 INSTRUMENT CLUSTER INSTALLATION
1. Spray a soap and water mixture onto the outer
Ambient Air Temperature 15
surface area of the instrument cluster. This will help
International Models Only the instrument cluster slide into the rubber mount
more easily.
Turn Signal Input, LH 6
2. Be sure the rubber mount inside the dash is fully
Turn Signal Input, RH 7 installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
3. Hold the dash securely and insert the instrument
INSTRUMENT CLUSTER REMOVAL cluster into the dash. Twist the instrument cluster
gently in a clockwise motion to properly seat the
NOTE instrument cluster into the rubber mount. Apply
pressure on the bezel while pressing down on the
Do not allow alcohol or petroleum products to come in
contact with the instrument cluster lens. instrument cluster.

1. Disconnect the wire harness connector from the
back side of the instrument cluster.

11

9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual 11.11
© Copyright Polaris Industries Inc.