Page 492 - Manual Oficina XP 1000 14-16
P. 492
ELECTRICAL
TEST 1: Resistance Value of Each Stator Leg 8. Example: The alternator current output reading
should be approximately 21 VAC at 1300 RPM
1. Measure the resistance value of each of the three between each ‘leg’.
stator legs: Y1 to Y2, Y1 to Y3, and Y2 to Y3. Each
test should measure: 0.07 - 0.13 Ω NOTE
CONNECT If one or more of the stator leg output AC voltage varies
TEST METER OHMS significantly from the specified value, the stator may
LEADS TO: READING need to be replaced.
Battery Charge Y1 to Y2 0.07 - 0.13 Ω
Coil AC VOLTAGE (VAC)
RPM READING
Battery Charge READING
Coil Y1 to Y3 0.07 - 0.13 Ω
1300 21 VAC ± 25%
Battery Charge 3000 47 VAC ± 25%
Coil Y2 to Y3 0.07 - 0.13 Ω
5000 79 VAC ± 25%
NOTE
If there are any significant variations in ohm readings STATOR (ALTERNATOR) REPLACEMENT
between the three legs it is an indication that one of the
stator legs may be weak or failed. Refer to Chapter 3 – Stator Cover Removal / Inspection,
page 3.46 procedure to service the stator.
TEST 2: Resistance Value of Each Stator Leg to NOTE
Ground
The stator cover can be removed with the engine
2. Measure the resistance value of each of the stator installed in the chassis.
legs to ground: Y1 to Ground, Y2 to Ground, Y3 to Be sure to thoroughly clean the area around the stator
Ground. cover prior to removal.
3. Each test should measure: Open Line (OL)
CONNECT
TEST METER OHMS
LEADS TO: READING
Battery Charge Y1, Y2, or Y3 Open Line
Coil to Ground (Infinity)
NOTE
Any measurement other than Infinity (open) will indicate
a failed or shorted stator leg.
TEST 3: Measure AC Voltage Output of Each
Stator Leg at Charging RPM
4. Set the selector dial to measure AC Voltage.
5. Start the engine and let it idle.
6. While holding the engine at a specified RPM,
separately measure the voltage across each ‘leg’ of
the stator by connecting the meter leads to the wires
leading from the alternator (Y1 to Y2, Y1 to Y3, Y2 to
Y3).
7. Refer to the following table for approximate AC
Voltage readings according to RPM. Test each leg at
the specified RPM in the table.
11.20 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
