Page 72 - Manual Oficina XP 1000 14-16

MAINTENANCE

BRAKE SYSTEM

BRAKE FLUID INSPECTION BRAKE PAD / DISC INSPECTION
Always check the brake pedal travel and inspect the 1. Check the brake pads for wear, damage, or
brake fluid reservoir level before each operation. If the looseness q.
fluid level is low, add DOT 4 brake fluid only.
2. Inspect the brake pad surface for excessive wear.
Brake fluid should be changed every two years. The fluid
should also be changed anytime the fluid becomes 3. Pads should be changed when the friction material
contaminated, the fluid level is below the minimum level, q is worn to .040″ (1 mm).
or if the type and brand of the fluid in the reservoir is
unknown.
The brake fluid master cylinder reservoir can be
accessed through the left front wheel well.
1. Position the vehicle on a level surface.
2. Place the transmission in PARK.
3. View the brake fluid level in the reservoir q. The
level should be between the MAX and MIN level
lines.

MEASUREMENT
Brake Pad Thickness
Service Limit: .040″ (1 mm)
4. Check surface condition of the brake discs.

5. Measure the thickness of the front and rear brake
discs.
6. The disc (s) should be replaced if thickness is less
4. If the fluid level is lower than the MIN level line, add than .170″ (4.32 mm).
brake fluid until it reaches the MAX level line.
5. Install the reservoir cap and apply the brake pedal
forcefully for a few seconds and check for fluid
leakage around the master cylinder fittings and the
brake caliper fittings.

MEASUREMENT
Brake Disc Thickness
Service Limit: .170″ (4.32 mm)

2.38 9926816 R06 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.