Page 152 - Manual Oficina Polaris RZR XP 1000 17-18

ENGINE / COOLING SYSTEM

5. If bearing replacement is required, remove the 3. Remove the water pump assembly from the engine
retaining ring and heat the stator cover around the by using a twisting motion as you pull out on the
bearing evenly with a heat gun. Tap cover on a soft housing.
work surface to remove the bearing from the
housing. A blind bearing puller can also be used.
Replace bearing if removed.
WATER PUMP HOUSING REMOVAL

NOTICE
The water pump housing can be serviced with the
engine installed in the chassis (see Chapter 3 – Water
Pump Removalpage 3.16).

1. Remove the coolant lines from the thermostat
housing, cylinder inlet and oil cooler. Leave them all
attached to the water pump housing.
4. If water pump service is required (impeller or
mechanical seal), refer to Water Pump Servicepage
3.18.

2. Remove the three long gold colored bolts q
retaining the water pump housing to the engine.

3.44 9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.