Page 425 - Manual Oficina Polaris RZR XP 1000 17-18

BRAKE SYSTEM

CALIPER INSTALLATION 4. Install the adjustment set screw and turn clockwise
1. Install the brake line onto the caliper taking care not until stationary pad contacts disc, then back off 1/2
to allow any debris to enter the caliper. turn (counterclockwise).
2. Install the caliper and torque the mounting bolts to
specification.

NOTE
If disc scraper q was removed, reinstall it upon caliper
installation.

5. Perform brake bleeding procedure as outlined earlier
in this chapter.
6. Install wheel and torque wheel nuts to specification.
TORQUE
Wheel Nuts:
120 ft-lbs (163 Nm)
TORQUE 7. Field test unit for proper braking action before putting
into service. Inspect for fluid leaks and firm brakes.
Front Caliper Mount Bolt w:
30 ft-lb (41 Nm) Make sure the brake is not dragging when pedal is
released. If the brake drags, re-check assembly and
installation.
3. Torque the banjo bolt e to specification.
NOTE
If new pads are installed, refer to Brake Burnishing
Procedurepage 9.16.

9

TORQUE
Banjo Bolt
15 ft-lbs (20 Nm)

9928492 R06 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual 9.21
© Copyright Polaris Industries Inc.